AM.CO.ZA (V6-LABEL/A3) V-Auto A3 Automatic Continuously Sheet Feed (ASF) Label Cutting Machine

Q: What should I do if I can't remove the Post-IT note after cutting the characters?

A: 1, Test knife should be carried out before output and the pressure should be adjusted to

the appropriate size.

2, check whether the carving knife is used for too long, whether the tip of the knife is

broken, the scratch of the new knife is very thin, and the scratch of the old knife is thicker

and obvious. Try it with a new carving knife.

Q: How to maintain the die cutting machine?

A: The cutting machine all use Japanese advanced oil-bearing, long-term operation without

refueling. After finishing the work every day, clean the dust with a soft brush. Glue left on

the frame can be cleaned with alcohol. Long-term operation in a dusty environment, more

than 2 years of use should ask maintenance personnel to remove the dust in the machine,

such as the engraving accuracy is reduced, but also to maintain the moving parts (fastening

and replacing worn parts).

Q: Why do die-cutting machines sometimes get out of control?

A: It may be that during transportation or use, the signal feeder is in poor contact, turn on

the machine and plug all the lines.However, if it cannot be solved, please contact your local

agent or customer repair center.

Q: Why does the film cutting machine stop?

A: This is due to long-term vibration or long-term use, temperature effect, so that the servo

drive board potential drift, frequent downtime phenomenon, please contact the local agent

or customer maintenance.

- 24－ AM.CO.ZA / Sales WhatsApp 060 600 6000 / Support WhatsApp 060 600 7000

24